CATEGORIES
FEATURED PRODUCTS
Auto Setting Control Pack (FACP-11)
Introduction:
The FACP-11 Auto Setting Control Pack accepts 4–20mA (or 1–5V) signals for precise valve angle control, with positioning accuracy up to 1/250. It supports automatic linear control across the full stroke range and includes enhanced features for a more convenient and efficient user experience.
Features & Specifications
Features:
Auto Calibration
High Control Sensitivity up to 250:1 (adjustable)
Easy Installation and Wiring
Compact and Lightweight Design
Encapsulated for dust and shock resistance
Compatible with 1kΩ, 5kΩ, 10kΩ
Enhanced Functionalities
1. Fail mode (upon control signal loss) 2. Self diagnosis
Open – fail to open Limit switches
Stop – fail to stop Potentiometer
Close – fail to close Motor
Electrical Specifications:
Power: 110vac or 220vac 50/60Hz
Control Signal Input : 4~ 20mA dc or 2~10vdc
Output Sibnal : 4~20mA 1%DC(RL:250ohm)
Calibration: Auto setting
Resolution: over 200
Power consumption:
Max 150W @110vac or 200W @220vac
FACP-11 Interface, Operation and Indicator Guide
Module Terminal Layout:
Indicator：
Lamp Status | Description |
Green Lamp On | Actuator is Opening |
Yellow Lamp On | Actuator is Operating |
Yellow Lamp Flashing Slowly | Fully open/closed |
Yellow Lamp Flashing Quickly | Fail, check limit switch, potentiometer, etc |
Red Lamp On | Actuator is Closing |
Press and hold the Auto Setting Switch for 3 seconds to start the actuator's auto-calibration, where it cycles twice to find and confirm its open and close limit positions for precise operation.
Wiring:
Blockage Protection:
Our modulating module is equipped with a blockage protection feature. If the actuator encounters a blockage, the module will automatically shut off the motor approximately 7 seconds after detection. Simultaneously, the yellow indicator lamp will flash rapidly,signaling that the actuator has entered Blockage Protection More.
To exit this mode, a reverse input signal must be provided. Upon receiving this signal, the actuator will deactivate the Blockage Protection Mode and resume normal operation.
Mode Switch Operation & Setting:
Feedback Output Adjustment (VR): Sensitive adjustment of "feedback output"
Limit Switch: Input terminal for digital limit is active "A"
• Limit switch common • Close limit switch • Open limit switch
Motor & Potentiometer
• Motor common • Open motor • Close motor • Ground
• Potentiometer P1 • Potentiometer P2 • Potentiometer P3
Auto Setting & Operating Instructions
Refer to the attached label on the pack and connect the wires for Power, Input, and Output, then turn on the power.
Press and hold the Auto Setting Switch for 3 seconds. The run (yellow) lamp will turn solid, and the actuator will cycle open (green) and close (red) twice.
If any errors occur, the run (yellow) lamp will flash rapidly. For product protection, the system will halt. The unit cannot be operated until the cause of the failure is cleared. Check the limit switch, potentiometer, motor, and other components as necessary.
After completion, input the signal (0%, 25%, 50%, 75%, 100%) to verify that the actuator opens correctly. Connect an indicator (current meter) to the Output Terminal to confirm the output current.If the open position is not accurate, check the Limit Cam position and the potentiometer's adjustment, then retry the setting process.